Roofcryl Roof Paint - PR1256

Roofcryl is based on a 100% pure acrylic which is suitable for direct application on prepared, new and weathered galvanized corrugated iron, asbestos-cement and clay-cement tiles.

Product Rating:


Product Code: PR 1256
Application: Roller & Brush
Appearance: Semi-gloss
Spread Rate: 7m2/l
Packaging: 5L & 20L
Colours: As per standard colour card
Guarantee: 10years

Tools & Resources

Download Data Sheet  |  Download MSDS  |  Colour Chart  |  Paint calculator  |  Get Adobe Reader
Please note, downloads may be blocked by popup blockers


  • It is also highly suited for use on other surfaces such as clay or tiles, gutters (asbestos cement and galvanized), as well as decorations such as flowerpots, etc.


  • UV-resistant for long lasting protection
  • Easy application by brush, roller or airless spray.
  • Easy to clean equipment with water after use.
  • Can be used on prepared cladding, galvanised garage doors, galvanised gutters and down pipes.
  • Has an outstanding adhesion capacity in the case of prepared galvanised surfaces, asbestos cement and cement roof tiles.
  • The product is water-based; dilution of the product and cleaning of equipment therefore performed at low cost.
  • Dries rapidly and is hard and dry within 4 hours; two (2) coats can therefore be applied within a day.
  • It is coloured with colour-fast pigments and will therefore not fade in the sun or be affected by alkaline salts. Has a build in Zinc Phosphate Anti Corrosion substance, therefore does not require a special primer (unless stated recommended primer). Zinc Phosphate is not toxic like the traditional Zinc Chromate rust-repellents. It may therefore be used on roofs that serve as water retention surfaces

Disclaimer: The technical information contained in this document are given in good faith and are meant to be used as a guideline by the specifier or user. Whilst we are confident about the quality of our products, we cannot accept any liability for the incorrect use or application of our products. Surface preparation forms an integral part of the scope of works and it is expected that the highest standards are maintained during surface preparation and application, to ensure that our products perform as intended. Always ensure to use the same product batch numbers, refrain from doing spot touch-ups and paint surfaces from corner to corner to prevent colour and sheen variance. As technology may change over time we reserve the right to change products to keep up with changes in raw materials or product trends without pre notice. Although we will always privail to keep clients informed about changes to be made, but cannot bind ourself to such notes Please ensure the use of the latest Technical Data Sheet.