Aquafibre Acrylic Waterproofing - WA1016

Aquafibre is an acrylic and reinforcing fibre blended waterproofing compound, forming a highly flexible non slumping liquid applied emulsion.

Product Rating:


Product Code: WA 1016
Application: Roller & Brush
Appearance: Low Sheen
Spread Rate: 1-1.2m2/l
Packaging: 1L, 5L & 20L
Colours: Black, Red, Brown, White and Light Grey

Tools & Resources

Download Data Sheet  |  Download MSDS  |  Paint calculator  |  Get Adobe Reader
Please note, downloads may be blocked by popup blockers


  • The presence of a long synthetic fibre mixed into the compound, eliminates the need for a separate waterproofing membrane and forms a homogeneous seamless waterproofing system.
  • Impa Aquafibre is an Acrylic waterproofing developed by the Impa Paints Research and Development Laboratories South Africa, reflecting the latest state of the art in waterproofing compounds, designed for waterproofing due to its exceptional water resistance, low dirt retention and alkali resistance.                                                                                                                                                                                          


  • Excellent waterproofing properties and very low water absorption after prolonged immersion in water.
  •  Excellent weather and ultra-violet resistance
  •  Will withstand movement of the substrate by exhibiting elongation and extensibility and will not harden or crack.
  • Resistance to Alkaline and Acidic atmospheres
  •  Excellent adhesion to all suitably prepared substrates
  •  Very little or no maintenance required, depending on the amount of traffic
  •  Lower installation cost since waterborne roof compounds are easily applied by brush, roller or squeegee.
  •  Excellent resistance to salt spray, mould and fungus.

Disclaimer: The technical information contained in this document are given in good faith and are meant to be used as a guideline by the specifier or user. Whilst we are confident about the quality of our products, we cannot accept any liability for the incorrect use or application of our products. Surface preparation forms an integral part of the scope of works and it is expected that the highest standards are maintained during surface preparation and application, to ensure that our products perform as intended. Always ensure to use the same product batch numbers, refrain from doing spot touch-ups and paint surfaces from corner to corner to prevent colour and sheen variance. As technology may change over time we reserve the right to change products to keep up with changes in raw materials or product trends without pre notice. Although we will always privail to keep clients informed about changes to be made, but cannot bind ourself to such notes Please ensure the use of the latest Technical Data Sheet.